Regular Storage Boxes Update

The regular storage boxes set got an update today. All existing boxes are now available in a new revision with an improved corner design and there are four new boxes in the set. The title image shows all current boxes of this set.

The new 2×4 sized box is a simple addition to complete the different sizes.

Also, I added three regular boxes with additional walls in the box. If you have parts which belong together, this is a nice solution.

Each wall has a special shaped top side, where you can put a 12mm label.

As with any other boxes, the design is highly optimised for 3d print. I recommend a nozzle size of 0.4mm or 0.6mm with a layer height of 0.2mm or 0.35mm for the 0.6mm nozzle.

You will find all details and a free set of boxes on the project page. There is also a catalog with a visual overview of all boxes and sets.

If you have any questions, missed information, or simply want to provide feedback, feel free to comment below. You can also contact me on this website or on Twitter. 😄

More Posts

How to Create a Prototype Connector from a Pin Header

In order to test the input panel, I had to connect the 14 lines to the test setup on a breadboard. Just using a pin header was too flimsy for me, because I often reuse ...
Read More

Unexpected Fill Sensor Problems

While testing the sensor panel, I ran into unexpected problems, requiring a small redesign. First, let me explain the simple working principle of the fill sensor circuit and what I tested so far. The Circuit ...
Read More

Round Corner Template Set for Woodworking

Sometimes I like to have rounded corners in my woodworking projects. It seems many people like to soften the spiky ends of their panels because there is a huge range of templates for routing. If ...
Read More

Pet Feeder Update

A short update about the progress with the sensor panel and photos of the final input panel board. I assembled the new boards and are testing the sensors. As soon as all tests are done, ...
Read More

How to Print the Turntable Platform

When I wrote part 3 of the pet feeder series, I did not expect the light transmission issues of this part. Now, I have two solutions with new revisions of the part. Solution 1: Epoxy ...
Read More

19″ Rack Fan Controller [1/2]

When I migrated several servers into a new server rack, I put my Arduino Uno based fan controller into a new enclosure. Not a great solution, but good recycling of this existing project and way ...
Read More