Flags play an important role in embedded software development. Microcontrollers and chips are using registers where single bits or combinations of bits play a big role in the configuration. All the bits and their role are described in the specification, but writing the bits directly in the code would be very confusing and hard to…
Author: Lucky Resistor
Testing the TPS61092 Boost Converter
For my current project I searched for a good boost power converter which is able to deliver continuous 400mA power for various sensors. There are an endless number of good boost converters around, but not many can be hand soldered to a board. I would really like to see some like the TPS61092 with SOIC…
PCBite Kit 2.0 from Sensepeek Arrived
Last week the new PCBite Kit 2.0 from Sensepeek arrived. The new kit comes with the great PCBite holder from the previous version, which are very useful to fasten a PCB for soldering, rework or analysis. New to this kit are the handy probes, which also can be magnetically attached to the mirror board. The…
Open Position for Step-Up Converter
For a current project I need a step-up converter to get 5 volts from 2.5V-5.5V input. The output of this converter is used to power sensors which drive motors and small heat elements from this source. The average consumed current is 160mA with a peek at 320mA. In the photo you can see the latest…
Adafruit PCB Coaster Arrived
Today I got the PCB coaster from Adafruit. They look so much better in real than on the photos in the shop. The coasters are made from 2.4mm FR4 PCB material. There is a transparent solder mask on the top to protect the copper and gold elements. The frame around the image is black silkscreen. I…
Boards in Good Quality from SeeedStudio Fusion
SeedStudio offered me a coupon to evaluate their PCB service “Fusion“. I am currently working on a new project, so I gave this service a try. I used the following options ordering the two boards: PCB Dimensions 68mm*108mm Impedance Control No Surface Finish HASL Lead Free Minimum Solder Mask Dam 0.4mm↑ Copper Weight 1oz. Plated…
Snowflake Power Converter
I designed a very simple power converter for the snow flake decoration. The snow flake boards require 3.3V, a voltage which is not commonly available in a household. Therefore the power converter takes 5V USB power and convert it into the required 3.3V. There is no fancy circuit inside of this box, lazily I simple…
Snowflake Component Side
Today I show you a little bit longer video about the assembly of the component side of the snowflake panel. Compared with the very small 0402 LEDs (1mm x 0.5mm) on the front side, the component side contains just regular 0805 resistors and capacitors. The first part of the video shows how I apply the…
Snowflake Assembly Video
Here a quick video of the snowflake assembly. It shows the assembly of the LED side of the panel using hot air. The assembly went without big problems, except there was a little bit excess solder on the pads. Therefore the LEDs do not lay perfectly flat on the board. More Snowflake Posts
Perfect Snowflake Panels from Eurocircuits
Eurocircuits delivered some perfect panels for the snow flake board. Each panel has five snow flake boards on it. This was an impressive good job from from Eurocircuits. There are a quite number of challenges to produce panels in this outstanding quality: The width of the small decorative lines on the front is just 0.15mm….