You can download a set of STL files for the organiser system for free. This set contains the following files:
- Regular boxes in these sizes:
- LR2052-111B – 1×1 (60×60×44mm)
- LR2052-112B – 1×2 (60×120×44mm)
- LR2052-122B – 2×2 (120×120×44mm)
- Flat boxes in these sizes:
- LR2052-211B – 1×1 (60×60×24mm)
- LR2052-212B – 1×2 (60×120×24mm)
- Tall boxes in these sizes:
- LR2052-312A – 1×2 (60×120×84mm)
- LR2052-322A – 2×2 (120×120×84mm)
- Rails grids:
- LR2052-105A – 2✕3
- LR2052-106A – 1✕3.
These free files are licensed under the Attribution-NonCommercial-ShareAlike 4.0 International license. Use them as you like, to test the quality of the objects and check if you can print them at your desired speeds.
The files in the free sets are licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.
There is also a free lid set, which contains nice different lids for the boxes.
You find all details about the storage boxes system on the project page and a complete list with all available boxes in the catalogue.
More Posts

Let’s Print a Cat/Pet Feeding Device (Part 1)
Do you own a 3D printer and would like to start a complex and challenging project? Then let's print a fully functional, programmable cat or pet feeding device! 😄 In this multi-part series, I will ...
Read More
Read More

Well Made Boards from PCBWay
I received new boards from PCBWay for the Always-On project. They are well made for a really low price. As you can see in the previous image, the layer alignment is very good. Also, I ...
Read More
Read More

Always-On Project
I just finished a new project, which is called Always-On. This project is a simple bidirectional bridge between the mains-voltage installation and an Adafruit Feather board as a controller. The idea is to have a ...
Read More
Read More

“Read SHT31” Command-Line Tool
For various sensors, attached to Raspberry-Pi computers, I wrote small command-line tools to read the sensor values over the I2C connection. While you can do this with a Python script directly, I found using a ...
Read More
Read More

Flat Storage Boxes Set for 3D-Print
Finally, my tests of the flat storage box are finished. 🎉 The main issue I had, was the spot for the labels. With the geometry I used in the regular and tall boxes, it took ...
Read More
Read More

Tall Boxes Ready for Download
The tall boxes set is ready for download, after successfully completing my tests. You will get carefully designed storage boxes, optimised for 3d print from the ground up. Only this weekend, from 2020-11-27 to 2020-11-29, ...
Read More
Read More