Flat Boxes Update

I just updated the flat boxes set. All existing boxes got a new revision, with an even better wall profile and there are five additional boxes in this set.

Improved Wall Profile

If you compare the corner for revision A and revision B, you see the difference easily.

The corner in revision A has an equal radius over the whole height, while revision B has a different radius but the same centre for the corner. I changed this profile to fix minor problems in the slicer.

Here you can clearly see the difference between revision A at the bottom and revision B at the top.

Additional Boxes

I also added five additional boxes to the flat set. One large 2×4 box and four different boxes with a grid.

As usual, you will find all details on the project page and in the catalog. Existing customers already got the updated and additional files in advance.

If you have any questions, missed information, or simply want to provide feedback, feel free to comment below. You can also contact me on this website or on Twitter. 😄

More Posts

Pet Feeder Update

A short update about the progress with the sensor panel and photos of the final input panel board. I assembled the new boards and are testing the sensors. As soon as all tests are done, ...
Read More

Input Panel – Request for Comments

I am currently working on the input panel board for the pet-feeding device. You are invited to review the board and send me your comments or suggestions via this page, Twitter or email. About the ...
Read More

Decorative, Massive, Modular Box

This design is not for everyone. 😅 A decorative and modular, but quite massive box. Built from 3d-printed parts, 5mm plywood panels and plenty 3x10mm wood screws. The instructions in this post show a basic ...
Read More

Why Supporting me on Patreon?

First, I'd like to thank you very much for reading this, 😄 because it means you are already a great supporter of my work. On my blog, you saw beautiful photos of electronic boards, got ...
Read More

Pet Feeder – Position Sensor Tests

I worked on testing the sensor board. The first tests I did were about the position sensor. Recap Let me recap the design of the position sensor in the device: The turntable has five position ...
Read More

Let’s Print a Cat/Pet Feeding Device (Part 7)

The seventh part of this series is all about the sensor board. It hosts the position sensor and four fill sensors. Speaking of sensors sounds complex, but these are just pairs of IR-LEDs and phototransistors ...
Read More