Tall Boxes Ready for Download

The tall boxes set is ready for download, after successfully completing my tests. You will get carefully designed storage boxes, optimised for 3d print from the ground up.

Only this weekend, from 2020-11-27 to 2020-11-29, all STL files in the shop are 20% off.

The new set fits well into the series. In the picture above you can see a comparison between the flat (red), regular (blue) and tall (violet) boxes. All of them will stack perfectly and match in the same grid.

Compared with the flat and regular boxes, the tall boxes required a slightly optimised wall profile. You can clearly see the additional ribs, which were required to prevent the walls from bulging. These ribs also take the additional load if you stack heavier boxes on top.

I also optimized the corner profile, which creates now an even better 3d print result as you can see in the picture above.

You will find all details on the project page for the storage boxes system with free downloads of a small set of boxes. In the catalog, you will get a visual overview of all parts and you can buy the full sets in the shop.

I hope you will find these boxes as useful as I do. Please let me know how you make use of these boxes, please share photos of your prints in action on Twitter! 😄

If you have any questions, missed information, or simply want to provide feedback, feel free to comment below.

More Posts

Logic Gates Puzzle 1

What kind of logic circuit do you see here? This logic circuit was optimised for symmetry and art. Can you see which function is implemented in this circuit? You find more about logic gates and ...
Read More

Huge Storage Boxes Update

Today I release a huge update of my storage boxes system for 3d-print. This update not only further improves the geometries of the models, but also extend the available sizes and variants. There are now ...
Read More

How to Create a Prototype Connector from a Pin Header

In order to test the input panel, I had to connect the 14 lines to the test setup on a breadboard. Just using a pin header was too flimsy for me, because I often reuse ...
Read More

Pet Feeder Update

A short update about the progress with the sensor panel and photos of the final input panel board. I assembled the new boards and are testing the sensors. As soon as all tests are done, ...
Read More

Logic Gates Puzzle 100

Assume, while digging out an ancient site from 450 AD, you found a mysterious stone with a digital display. Your analysis finds five inputs for five segments (a-e) and six outputs (1-6). It seems to ...
Read More

Art Like Boards from OSHpark

For the pet feeding device, I ordered boards from OSHpark with the "After Dark" style. This colour combination of the black substrate with the copper and transparent solder mask is just beautiful. I made this ...
Read More