Here a quick video of the snowflake assembly. It shows the assembly of the LED side of the panel using hot air.
The assembly went without big problems, except there was a little bit excess solder on the pads. Therefore the LEDs do not lay perfectly flat on the board.
More Snowflake Posts

Programming the Snowflake Decoration
In this brief article, I will discuss the requirements to flash a custom firmware to your Pimoroni snowflake decoration. I assume you have some programming knowledge and have previously worked with an Arduino Uno or ...
Read More
Read More

Snowflake Decoration Available on the Pimoroni Store
We have some great news about my Snowflake Decoration: Starting today, you can buy an assembled version of the project from Pimoroni that can be shipped worldwide. Pimoroni did an excellent job on this project ...
Read More
Read More

Perfect Snowflake Panels from Eurocircuits
Eurocircuits delivered some perfect panels for the snow flake board. Each panel has five snow flake boards on it. This was an impressive good job from from Eurocircuits. There are a quite number of challenges ...
Read More
Read More

Recreating the Human Perception of the Snowflake Sparkling Effect
The sparkling lights on the real snowflake decoration are stunning and beautiful. Yet, it seems to be impossible to capture the effect with a video. After some experiments, I created a new video with a ...
Read More
Read More

Snowflake Project Documentation
I wrote a short page about the snowflake project from the end of 2017. On the page, you will find a summary of the project and the link to the repository with all the required ...
Read More
Read More

Perfect Prototype Boards from Eurocircuits
Today prototype boards from Eurocircuits arrived. The quality of this boards is outstanding. I do not know any other board house which delivers this incredible quality of boards. They really thrive for perfection ...
Read More
Read More