Here a quick video of the snowflake assembly. It shows the assembly of the LED side of the panel using hot air.
The assembly went without big problems, except there was a little bit excess solder on the pads. Therefore the LEDs do not lay perfectly flat on the board.
More Snowflake Posts
Perfect Snowflake Panels from Eurocircuits
Eurocircuits delivered some perfect panels for the snow flake board. Each panel has five snow flake boards on it. This was an impressive good job from from Eurocircuits. There are a quite number of challenges ...
Snowflake Project Documentation
I wrote a short page about the snowflake project from the end of 2017. On the page, you will find a summary of the project and the link to the repository with all the required ...
How to Wire the Snowflake Decoration
If you own an original snowflake kit or produced boards from the sources, you have to wire them by yourself. The pre-assembled kit from Pimoroni comes with some nice flex-cables, but you may want to ...
Programming the Snowflake Decoration
In this brief article, I will discuss the requirements to flash a custom firmware to your Pimoroni snowflake decoration. I assume you have some programming knowledge and have previously worked with an Arduino Uno or ...
Snowflake Decoration Available on the Pimoroni Store
We have some great news about my Snowflake Decoration: Starting today, you can buy an assembled version of the project from Pimoroni that can be shipped worldwide. Pimoroni did an excellent job on this project ...
Snowflake Power Converter
I designed a very simple power converter for the snow flake decoration. The snow flake boards require 3.3V, a voltage which is not commonly available in a household. Therefore the power converter takes 5V USB ...