Here a quick video of the snowflake assembly. It shows the assembly of the LED side of the panel using hot air.
The assembly went without big problems, except there was a little bit excess solder on the pads. Therefore the LEDs do not lay perfectly flat on the board.
More Snowflake Posts

Perfect Prototype Boards from Eurocircuits
Today prototype boards from Eurocircuits arrived. The quality of this boards is outstanding. I do not know any other board house which delivers this incredible quality of boards. They really thrive for perfection ...
Read More
Read More

Snowflake Component Side
Today I show you a little bit longer video about the assembly of the component side of the snowflake panel. Compared with the very small 0402 LEDs (1mm x 0.5mm) on the front side, the ...
Read More
Read More

Recreating the Human Perception of the Snowflake Sparkling Effect
The sparkling lights on the real snowflake decoration are stunning and beautiful. Yet, it seems to be impossible to capture the effect with a video. After some experiments, I created a new video with a ...
Read More
Read More

Programming the Snowflake Decoration
In this brief article, I will discuss the requirements to flash a custom firmware to your Pimoroni snowflake decoration. I assume you have some programming knowledge and have previously worked with an Arduino Uno or ...
Read More
Read More

Snowflake Project Videos
From the beginning of the snowflake project, I tried to create photos or videos which capture the actual beauty of the decoration. Here are the two more recent videos I created: Differences to the Real ...
Read More
Read More

How to Write Custom Snowflake Patterns
In this article, I will discuss how to write custom patterns for your snowflake decoration. This is a rather advanced topic, and there are a number of prerequisites that are required and listed below. Nevertheless, ...
Read More
Read More